图片名称
图片名称

Classification of linear bearings

2023-04-25

(1) Standard type, clearance adjusted linear bearing, open linear bearing, extended linear bearing, general linear bearing (2) Flange type linear bearings can be divided into: round flange type, flange type, elliptical flange type, guide circle flange type, guide method flange type, guide ellipse flange type, and extended circle flange type.

图片名称

What is needle roller bearing

2023-04-25

Needle roller bearings are equipped with thin and long rollers (roller length is 3~10 times the diameter, the diameter is generally not greater than 5mm), so the radial structure is compact, its inner diameter size and load capacity and other types of bearings at the same time,

图片名称

What Is Thrust Bearing?

2023-04-25

Thrust bearings are generally composed of two thrust gaskets or more thrust gaskets and a number of rolling bodies. Generally, thrust gaskets are divided into shaft plates and seat plates. The most common type of rolling bodies is generally composed of iron or copper cages. The most common type of bearing is steel ball thrust bearing. Thrust bearings are designed and used to withstand axial loads.

图片名称

What is deep groove ball bearing

2023-04-25

Deep groove ball bearing (GB/T 276-2003) formerly known as single row radial ball bearing, is the most widely used rolling bearing. It is characterized by small friction resistance, high speed, can be used to bear radial load or radial and axial simultaneous action of the combined load on the machine parts, can also be used to bear axial load on the machine parts, such as small power motor, car and tractor transmission, machine tool gear box, general machines, tools, etc.

图片名称

Deep groove ball bearing installation method

2023-04-25

Deep groove ball bearing installation method one: pressing into the match: When the inner ring of the bearing is fitted tightly with the shaft, and the outer ring is fitted loosely with the bearing seat hole, the bearing can be mounted on the shaft by press first, and then the shaft and bearing together are loaded into the bearing seat hole. During the press mounting, an assembly sleeve made of soft metal material (copper or mild steel) is placed on the end face of the inner ring of the bearing. The outer ring of the bearing is fitted tightly with the bearing seat hole. The bearing can be first pressed into the bearing seat hole, then the outer diameter of the assembly sleeve should be slightly less than the diameter of the seat hole. If the bearing ring is a tight fit with the shaft and seat hole, the installation of the inner ring and the outer ring should be pressed into the shaft and seat hole at the same time, and the structure of the assembly sleeve should be able to hold the end face of the inner ring and the outer ring of the bearing at the same time.

< 1 >